Quantcast
Channel:
Viewing all articles
Browse latest Browse all 59170

Forum Post: RL78G12 P60 as Output

$
0
0
Hi, In a new RL78G12 design project, I have P60 set to be an output with an initial value of 1.  Since this is an open drain output, I have a pull-up externally to 3.3V and the signal is driving an input on another IC that is also powered by 3.3V.  I have set up the initial code with the code generator as part of an E2 Studio project.  When I debug using the E1 emulator, the port starts out as a 0 instead of a 1, even though when I examine the Port and Port Mode registers using the debugger, they are set as I expect them. Has anyone got any suggestions as to what I am missing or what might be wrong here Thanks, Howard

Viewing all articles
Browse latest Browse all 59170

Trending Articles