Here is the way I have connected the module to the SK board: Module S7 (176pin) Notes SPI_CLK 8 P4-12 39 With 47k pullup SPI_MISO 10 P4-10 41 With 47k pullup SPI_INT 14 P0-1 168 With 47k pullup SPI_MOSI 16 P4-11 40 With 47k pullup SPI_CS 17 P4-13 38 With 10k pullup CHIP_PWD# 19 P2-4 52 With 100k pulldown SD_D2 15 With 10k pulldown GND 5,9,18,26 To 0 Volts 3V3 11 To 3V3 VDDIO_SDIO 6 To 3V3 DVDD_GPIO 20 To 3V3 The CHIP_PWD# pin goes to P9-4 on the HMI board (224pin) , however this pin does not exist on the SK board (176 pin) so I have put it to P2-4 The module is connected to the SK board via a 3 inch (75mm) ribbon cable. Software later today, I will keep you all posted All comments MOST welcome - alan..
↧