Quantcast
Channel:
Viewing all articles
Browse latest Browse all 59170

Forum Post: Minimum/Breakout circuit for R5F212L4SNFP

$
0
0
I have R5F212L4SNFP MCU & E8 debugger (not E8a). I have made a breakout circuit for this MCU. 1. Is this the minimum circuit ok? 2. I have added 4.7K/0.1uF for reset circuit, it is ok? Hardware manual says 4.7k or more. It dont specify 0.1uF cap 3. Mode pull resistor is 4.7uF 4. Vcc & Vss decoupled by 0.1u+10u Below image is for E8 used with R5F212L4SNFP. Do it give full step by step debug capability using E8 or any other pin required?

Viewing all articles
Browse latest Browse all 59170

Trending Articles