Hello, I am currently using the evaluation board YCONNECT-IT-TPS-1 V1.20 and am having a communications connection problem with the sample software. I am attempting to download and debug the sample software that came with the device via the IAR workbench to the board, but this is the error I am seeing when I attempt to do this: The user manual V850ES/JH3-H Configuration R21UT0221ED0201, Chapter 3 has been followed (pg24) inclusively, yet this problem cannot seem to be corrected. According to this manual, I should have the Minicube2 debugger selected as my debugger for the project, which I do. And the drivers for the Minicube2 seem to be installed within the IAR Workbench directory as seen below: The wires I have attached to the board are as follows: USB to CN11 for power/debugging, an Ethernet cable to CN2 and a UART connected to CN15 for serial communication. This all follows the start up guide provided with the board. Suggestions would be appreciated. Thank you.
↧